Each RX Sensor contains 4 receive diodes and 1 transmit diode.
Add an extra Sensor to the front or rear of a large vehicle.
A cable extension is usually required for a rear sensor.

The TX sensor features a 3-diode array with sequential transmission.
This achieves faster pulsing and higher power output without overheating.
Purpose: To defeat the DragonEye hand-held Laser Speed-Guns.
FRONT: 1 x TX Sensor (on F2 port) of the Control Box without a splitter.

The TX sensor features a 3-diode array with sequential transmission.
This achieves faster pulsing and higher power output without overheating.
Purpose 1: To defeat the DragonEye hand-held Laser Speed-Guns. 
Purpose 2: To enable 3 Sensor installations at the Rear of a vehicle,
with 2 Rear Ports (R1 and R2) in the Control Box.

In areas where the Vitronic PoliScan is prevalent, 2 x RX Sensors are
angled outwards to improve detection of scanning-laser Speed Cameras
that target the rear of passing vehicles. The TX Sensor provides a much more powerful return-response over a wider area.

FRONT: When 2 x TX Sensors are fitted, the T-Splitter is used to
combine them on F2 port. RX Sensors are on F1 port and F3 port.
REAR: One TX Sensor Gen2 (on R2 port without requiring a Splitter).
It must be combined with at least one RX Sensor on R1 port.
REAR: One TX Sensor Gen2 (on R2 port without requiring a Splitter).
2 x RX Sensors are combined through a T-Splitter. A single extension
cable is connected to the R1 port at the Control Box.

AntiLaser HI-Fi Audio Control Set
(Upgrade from "beeper" version)
(HW6 version)
(Accessories included)

With older (beep-alert) AntiLaser Priority versions:
Replaces the standard Control Box and Control Panel.